Laser Cut 304 Stainless Steel Sheet 0.5mm 6mm Custom Size 1219mm 2438mm

This laser cut 304 stainless steel sheet is produced for buyers who need finished blanks rather than full mill sheets. We keep 304 coil and plate stock in thicknesses from 0.5mm to 6mm, then cut each order on fiber laser beds to the drawing, so a fabricator receives parts that are ready to weld, bend or assemble without a second handling step. The material itself is the standard austenitic 18/8 alloy with a density of 7.93 g/cm3 and a tensile range of 515 to 1035 MPa, which keeps the sheet ductile enough for forming while holding the strength demanded by structural brackets, covers and frames.

Because every blank is nested and cut from one heat number, the whole shipment carries a single mill certificate and a single surface batch. That consistency removes the colour and finish mismatch that appears when panels are sourced from several distributors. Sheets are protected with laser-grade PE film before cutting, so the cut face stays free of scratches and the protective layer survives transport and site handling.

• Cut to Drawing Tolerances: Fiber laser cutting holds plus minus 0.02mm on linear dimensions and 0.1mm on hole positions, which is tight enough for bolt-on assemblies and eliminates on-site reaming or grinding.
• One Heat Number per Order: Nesting all blanks from a single coil or plate batch keeps grain direction, thickness and surface identical across the shipment, so visible parts match after installation.
• No Heat-Affected Distortion: Low-heat fiber cutting with nitrogen assist leaves a clean, oxide-free edge that needs no pickling, protecting corrosion resistance along the cut line.
• Thickness Range from 0.5mm: Thin gauges for appliance covers and thicker 6mm plate for frames can be supplied in the same container, cutting freight and clearing cost for mixed projects.
• Scratch-Safe Packing: Laser-grade PE film is applied before cutting and hardboard edges are added afterwards, keeping the 2B or hairline finish intact through sea freight.
• Full Traceability: Each pallet is labelled by item, thickness, heat number and quantity, with EN 10204 3.1 mill certificates issued against the same reference.

Cut to size 304 blanks are used for electrical cabinet panels, machine guards, conveyor covers, food processing tables, elevator cladding, signage frames and architectural trim. Fabricators order them when the workshop has no in-house laser or when subcontract cutting lead time is longer than the project schedule. Because the blanks arrive flat, deburred and filmed, they move straight into bending and welding, which shortens the assembly cycle and reduces scrap generated by manual cutting.

Finished blanks are interleaved with PE film, stacked flat on fumigation-free plywood, edge protected with hardboard and steel strapped for container loading. Every order is checked for dimensions, squareness, flatness and surface before packing, and an EN 10204 3.1 mill certificate, inspection report and packing list travel with the shipment. Standard stock sizes ship within seven working days, while fully cut to size orders are ready in fifteen to twenty days depending on quantity.